Integra RDV-1.1 User Manual download pdf (Page 15)

100

Before Use

The Worldwide model has a voltage selector for compat-

ibility with power systems around the world. Before you

plug in this model, make sure that the voltage selector is

set to the correct voltage for your area. If it isn’t, use a

small screwdriver to set it as appropriate. For example, if

the voltage in your area is 120 volts, set the selector to

“120V.” If it’s between 220 and 230 volts, set it to “220-

230V.”

Notes:

• The supplied batteries should last for about six

months, although this will vary with usage.

• If the remote controller doesn’t work reliably, try

replacing both batteries.

• Don’t mix new and old batteries, or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent possible leakage

and corrosion.

• Flat batteries should be removed as soon as possible to

prevent possible leakage and corrosion.

To use the remote controller, point it at the RDV-1.1’s

remote control sensor, as shown below.

Notes:

• The remote controller may not work reliably if the

RDV-1.1 is subjected to bright light, such as direct

sunlight or inverter-type ﬂuorescent lights. Keep this

in mind when installing the RDV-1.1.

• If another remote controller of the same type is used in

the same room, or the RDV-1.1 is installed close to

equipment that uses infrared rays, the remote control-

ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-

ently, thereby draining the batteries.

• The remote controller may not work reliably if the

RDV-1.1 is installed in a rack behind colored glass

doors. Keep this in mind when installing the RDV-1.1.

• The remote controller will not work if there’s an obsta-

cle between it and the RDV-1.1’s remote control sen-

sor.

Setting the Voltage Selector

(Worldwide model only)

Installing the Remote’s Batteries

To open the battery compartment, press

the small hollow and slide off the cover.

Insert the three supplied batteries (AA/R6)

in accordance with the polarity markings

inside the battery compartment.

Put the cover onto the remote controller

and slide it shut.

VOLTAGE SELECTOR

220-230

120

COAXIAL OPTICAL OPTICALCOAXIAL

DIGITAL

DIGITAL 2

(

BALANCED

)

AES/EBU

AUDIO

OUT

MODEL NO.

RDV

1.1

DVD

PLAYER

AC INLET

D. MIX FRONT SURR

CENTER SURR

SUB

WOOFER

YPB PR

OUT

REMOTE

CONTROL

VIDEO

OUT

COMPONENT

VIDEO

VIDEO VIDEO

VIDEO

232

HDMI

VIDEO

S400

(

AUDIO

)

AUDIO

OUT

HD VIDEO

OUT

COMPONENT

TRIGGER

SURR

MODE

(

AUDIO OUT

)

220-230

120

VOLTAGE SELECTOR

Using the Remote Controller

30˚

RDV-1.1

Approx. 16 ft.

(5 m)

Remote control sensor

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Comments to this Manuals

No comments

Integra RDV-1.1 User Manual Page 15

Comments to this Manuals

Related products and manuals for DVD players Integra RDV-1.1