Integra DTR-5.2 User Manual download pdf (Page 46)

Using a Macro function

Programming the Direct Macro function

With the direct macro function, you can program a series of button

operations as a macro into the DIRECT MACRO button so the

macro can be executed with just one touch. Note that for the direct

macro function, only one macro can be programmed. For example,

to program the macro described on the previous page for the

DIRECT MACRO button, perform the steps given below.

1. Press and hold down any one of the eight MODE

buttons, press the DIRECT MACRO button, and then

release both buttons.

When you press the MODE button, it lights green and the

SEND/LEARN indicator lights. When you press the DIRECT

MACRO button, the indicator turns off. When you release the

buttons, the indicator flashes briefly and then lights again.

2. Press the operation buttons you wish to program in

order (in this case, press RCVR MODE → ON → CD

(INPUT SELECTOR) → CD MODE → playback ( )

button).

When you press each button, the SEND/LEARN indicator turns

off. When you release the button, the indicator lights.

3. Press the DIRECT MACRO button to complete the

procedure.

The SEND/LEARN indicator flashes twice slowly.

4. Check to see if the macro has been properly

programmed.

Notes:

• You may program up to 16 button operations into the direct

macro function. If you try to program a 17th operation, it will be

ignored, and programming is stopped.

• If no button is pressed for more than 30 seconds during the

programming, the SEND/LEARN indicator flashes three times

quickly, and the remote controller exits the programming mode.

Resume from Step 1.

• If you perform an invalid operation during programming, the

SEND/LEARN indicator flashes three times quickly, and the

remote controller exits the programming mode. Resume from

Step 1.

Running a Direct Macro function

Perform the procedure below to run a direct macro function that you

have programmed into the remote controller. After programming a

direct macro, you should always run it at least once to make sure that

it has been programmed properly.

1. Point the remote controller at the DTR-5.2 and press

the DIRECT MACRO button.

It may take a while for the macro to finish transmitting, so be

sure to continue pointing the remote controller at the device until

the SEND/LEARN indicator turns off.

Tips:

• If you erase or change the command of a button programmed in

the direct macro, that operation of that button will no longer

work in the macro. In this case, it will be necessary for you to

reprogram the direct macro in order to avoid incorrect operation.

• The codes programmed into a direct macro will be transmitted at

an interval of 0.5 seconds. However, some devices may not be

able to complete one operation in 0.5 seconds and may miss the

next code. In this case, after pressing one operation button, you

can press the same MODE button again before pressing the next

operation button to add another 0.5 seconds between the two

operations.

HOME THEATER CONTROLLER

441M

DIRECT MACRO CD MODE

RCVR MODE

(CD playback)

(INPUT

SELECTOR)

MODE buttons

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments

Integra DTR-5.2 User Manual Page 46

Comments to this Manuals

Related products and manuals for AV receivers Integra DTR-5.2